Assembling Module -D- rev 0.4

B I U S link image code list	Show page Syntax
!Switching board [https://remoteqth.com/img/wiki-modular-ant-sw-16c.jpg] ❏ Diode D4 D5 D6 D7 D8 '''{.redka#id color: #f00;}necessary to observe polarity{/}''' [https://remoteqth.com/img/wiki-modular-ant-sw-06.jpg] ❏ What is the capacity and varistor. Capacity is marked '''472'''. Varistor is marked '''180K07D''' [https://remoteqth.com/img/wiki-modular-ant-sw-17c.jpg] ❏ capacity C1 C2 C3 C4 [https://remoteqth.com/img/wiki-modular-ant-sw-18c.jpg] ❏ varistor V1 V2 V3 V4 [https://remoteqth.com/img/wiki-modular-ant-sw-19c.jpg] ❏ Connector K1 K2 [https://remoteqth.com/img/wiki-modular-ant-sw-20c.jpg] ❏ '''{.redka#id color: #f00;}Set soldering station to MAX 260°C{/}''' and soldering relay RL1 RL2 RL3 RL4 RL5 RL6 ❏ ''Because wire pins from relay are flat (not cylinder), you can avail the gap to shift relay more from the edge of the PCB that does not extend beyond the edge to the next module.'' [https://remoteqth.com/img/wiki-modular-ant-sw-11.jpg] ❏ Because of copper paths on the circuit board are rated at 8A, for the using of the full load relay until 16A it is necessary to apply a higher layer of tin on the unmasking of all RF paths. [https://remoteqth.com/img/wiki-modular-ant-sw-22c.jpg] ❏ Soldered two ground and three signal wire + mount four locknuts. ❏ Now module ready to connect control cable. [https://remoteqth.com/img/wiki-modular-ant-sw-0.png\|noborder] ---- [<-- Back to Index\|12x4 modular Antenna switch] \| [<-- Web page\|https://remoteqth.com/modular-antenna-switch.php]
Password Summary of changes