IP Remote hardware Switch

B I U S link image code list	Show page   Syntax
!The hardware * Schematics ** [rev 05 .PDF|https://remoteqth.com/hw/ip-sw-05.pdf] ** [rev 05 .SVG|https://remoteqth.com/hw/ip-sw-05.svg] * PCB ** [rev 05 .PNG|https://remoteqth.com/hw/ip-sw-pcb-05.png] ** [rev 05 .SVG|https://remoteqth.com/hw/ip-sw-pcb-05.svg] ** 3D View [Control 4,5MB|https://remoteqth.com/x3d-preview.php?x3d=ip-sw-control-05] ** 3D View [Relay 8,5MB|https://remoteqth.com/x3d-preview.php?x3d=ip-sw-relay-05] !!Relay front side [https://remoteqth.com/img/wiki-ipsw-front-panel.png|noborder] * '''1-16''' - green LED signalized switched relay. * '''white square''' - sign defines the type of equipment. !!Relay back side [https://remoteqth.com/img/wiki-ipsw-rear-panel.png|noborder] * '''DATA''' - not used. * '''USB''' - +5V DC POWER supply, or upload arduino firmware (needs open jumper JP5). * '''ETHERNET''' - RJ45 LAN connector. * '''OUTPUTS''' - 14 relay outputs and GND[https://remoteqth.com/img/wiki-ipsw-relay.png|noborder] !!Control switch [https://remoteqth.com/img/wiki-ipsw-control-panel.png|noborder] * '''1-11''' - rotary switch. * '''12-15''' - four rock switch with LED. * '''16''' - pushbutton. * '''LINKED''' - green LED signalized: ** '''connect''' with relay board over IP LAN ** '''latency''' (delay) same as LED OFF time. * '''CONFIG button ''' need enable in firmware and preset string. !!!Redirection procedure ** turn the rotary switch to the number that corresponds to the order of relay board, on this you want redirect control ** press the button for three seconds during which the LED goes off ** after LED on release the button ** now wait to the redirection of control - indicated LINK LED on.
Password Summary of changes