Manual IP switch II

B I U S link image code list	Show page   Syntax
!!Control box May be preset via CLI (command line interface). How to access * connect micro USB cable * run terminal - for example Ctrl+Shift+M in Arduino IDE * set baudrate to 115200 and No line ending. [https://remoteqth.com/img/wiki-ip-sw-mk2-cli.png|noborder] CLI contains some commands for set or show information. *'''?''' - show status *'''/''' - enable/disable trasfer PTT (pin 18 on D-SUB connector) as one button (default number 8), may be change in firmware source edited with line{{byte ButtonUseForPttTransfer= 8; // 1-8 }} *'''.''' - Listing detected/stored ip-relay by ID sufix, for switching between it *'''+''' - Switch between source of network ID sufix eeprom/BCD switch *'''#''' - set network ID prefix (four high bit) in hexadecimal format (0-f). *'''&''' - send broadcast packet for find relay devices in local network
Password Summary of changes