Sensors
This revision is from 2013/04/04 23:51. You can Restore it.
For finding adress equipment on I2C bus you can use a pop-up window 
After plug I2C device press refresh button and read adress your device
Temperature(Edit)
You can enable up to 'eight temperature sensors, or disable.
- I2C adress: must be two hexadecimal numbers.
- Temp 2 name: can have maximum 25 characters.
A/D converter(Edit)
You can enable up to 'two A/D converter, or disable. Every converter included four input
- I2C adress: must be two hexadecimal numbers.
- Temp 2 name: can have maximum 25 characters. If set the name as n/a input will be disable in controll page.
- Coefficient: this sis coefficient of voltage divider, each input can have a different.
- Ftom/To: value limits for setting collor in controll section.
LM75 temperature sensor HEX address switch table
| A0 | A1 | A2 | HEX |
| - | - | - | 48 |
| - | - | x | 49 |
| - | x | - | 4a |
| - | x | x | 4b |
| x | - | - | 4c |
| x | - | x | 4d |
| x | x | - | 4e |
| x | x | x | 4f |