Remote multi rotator control

Block diagram(Edit)

Rack case(Edit)

• Version 4
• Version 3

Rotators module(Edit)

• Assemble version 3.3
• Assemble version 3.2
• Assemble version 3.1
• Assemble version 3.0
• Assemble version 2.1
• version 2.0
• AC rotator Examples

GPIO board for model RPI2/B2+(Edit)

• Version 2.2
• Version 2.1

GPIO board for model B(Edit)

• Assemble version 1.1
• Assemble version 1.0

How to assemble components to complete server(Edit)

software Configuration(Edit)

• configure from master tree Arduino firmware by K3NG, or download preconfigured version
• 2014-07-08.zip
• 2013-10-26.zip
• Change the Baud rate to 9600 (at K3NG source code its 115.k baud the preset)

  #define SERIAL_BAUD_RATE 9600

• install RemoteQTH server on SD card for Raspberry PI
• login (yourcall/1234)to web interface and update server from status page
• change login and password in menu SETTINGS/LOGIN
• in menu SETTINGS/WEB RELAY change name for first relay to POWER and others set to n/a
• in menu SETTINGS/ROTATORS set number on Four and configure each rotator
• set Name
• replug usb and find ID from pop-up window
• From/To azimuth without overlap
• Get/Set sommand by defaukt
• Your locator and apply
• For detection USB interface replug all interface by turning power off from the menu CONTROL/SWITCH RELAY - Recognized USB devices shown in STATUS page as rot1 , rot2, rot3 and rot4